Notifications
Clear all
IBICO74
Skupina: Registrovaný
Přidal se: 2018/08/09
Active Member
1
|
I figured out what was wrong.
The pin for the idler wheel h... In forum Hardware, firmware and software help |
před 6 years | |
|
I get the same error.
17:24:04.034: Unknown G code: $91 G21... In forum How do I print this? (Printing help) |
před 6 years | |
| Anyone know where I could put the profiles in the Linux vers... | před 6 years | |
| XYZ calibration fail, but print normal | před 6 years | |
|
I got the same issue with my sensor.. No reaction and under ... In forum Hardware, firmware and software help |
před 6 years | |
|
The preset that came with my drivers was causing lots of war... In forum Print tips (Archive) |
před 6 years | |
|
I got the same problem. Recently all long print fail after p... In forum Hardware, firmware and software help |
před 6 years | |
| I got a perfect K value by printing a cube 400% and then dro... | před 6 years | |
| K value calibration in menu | před 6 years | |
| I struggled for days before finding out that there is a cust... | před 6 years | |
| My prusa does strange things | před 6 years |