Notifications
Clear all
hyperion
Skupina: Registrovaný
Přidal se: 2024/11/01
Active Member
1
|
FWIW the most recent firmware seemed to fix this issue, alth... In forum Hardware, firmware and software help |
před 5 months | |
|
Did you ever solve this problem? I’m having the same issue,... In forum Hardware, firmware and software help |
před 6 months | |
|
I'm sad to report that none of these changes affected the is... In forum Hardware, firmware and software help |
před 10 months | |
|
I searched for this setting in Prusa Slicer but couldn't fin... In forum Hardware, firmware and software help |
před 10 months | |
|
Thanks for the response. Just to be sure I reinstalled the ... In forum Hardware, firmware and software help |
před 10 months | |
|
Extruder pauses 1-2 seconds on tool change? In forum Hardware, firmware and software help |
před 10 months |