Notifications
Clear all
Henry
Skupina: Registrovaný
Přidal se: 2018/09/05
Eminent Member
2
| I think i will stick with Prusa link thank you. | před 3 years | |
| Octoprint is not an option. I have used octoprint in the pas... | před 3 years | |
| Option for a camera. | před 3 years | |
|
You need to print it in vase mode. In forum PrusaSlicer |
před 3 years | |
|
Turn off heated bed and thermistor In forum Hardware, firmware and software help |
před 6 years | |
| Thank you. That's where i put it but i thought it did more t... | před 6 years | |
| Extruder idler plug | před 6 years | |
| I just got through with a chat with customer support and the... | před 6 years | |
| I will check the trap nut tomorrow. Other information i have... | před 6 years | |
| New MK3 calibration issue | před 6 years |
Stránka 2 / 2
Předchozí