Prusa3D Forum

Notifiche

Cancella tutti

hdt551

Gruppo: Registrato

Registrato: 2021/05/05

Active Member

	In all the betas/updates I have used, something must have go... Nel forum PrusaSlicer	3 years fa
	It seems it doesn't matter what I set in the configuration w... Nel forum PrusaSlicer	3 years fa
	I did not think to try running the wizard for an option like... Nel forum PrusaSlicer	3 years fa
	Option to disable "Check for updates" is gone Nel forum PrusaSlicer	3 years fa
	I don't think I will do a factory reset since I have never m... Nel forum PrusaSlicer	4 years fa
	I have never done anything like modifying the gcode (M92 or ... Nel forum PrusaSlicer	4 years fa
	I didn't understand. I guess the e-step is the extrusion mu... Nel forum PrusaSlicer	4 years fa
	It is a Prusa i3 MK3S. Is that a configuration setting or do... Nel forum PrusaSlicer	4 years fa
	I can say those scaling factors have been needed since I fir... Nel forum PrusaSlicer	4 years fa
	default x,y scale factor? Nel forum PrusaSlicer	4 years fa
	Very excellent. It looks like it took changing Pattern angle... Nel forum Hardware, firmware and software help	4 years fa
	support.zip File attached. Nel forum Hardware, firmware and software help	4 years fa
	Support Enforcers not working correctly (again) Nel forum Hardware, firmware and software help	4 years fa
	I removed the block enforcer and used paint support, being c... Nel forum Hardware, firmware and software help	4 years fa
	how to have support generated only from bottom to top of hol... Nel forum Hardware, firmware and software help	4 years fa

Statistiche Forum

565 Forum

63.8 K Discussioni

447.3 K Post

24 Online

69.3 K Utenti

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso