Prusa3D Forum

Notifications

Clear all

hdt551

Groupe: Enregistré

A(ont) rejoint: 2021/05/05

Active Member

	In all the betas/updates I have used, something must have go... Dans le forum PrusaSlicer	il y a 3 years
	It seems it doesn't matter what I set in the configuration w... Dans le forum PrusaSlicer	il y a 3 years
	I did not think to try running the wizard for an option like... Dans le forum PrusaSlicer	il y a 3 years
	Option to disable "Check for updates" is gone Dans le forum PrusaSlicer	il y a 3 years
	I don't think I will do a factory reset since I have never m... Dans le forum PrusaSlicer	il y a 4 years
	I have never done anything like modifying the gcode (M92 or ... Dans le forum PrusaSlicer	il y a 4 years
	I didn't understand. I guess the e-step is the extrusion mu... Dans le forum PrusaSlicer	il y a 4 years
	It is a Prusa i3 MK3S. Is that a configuration setting or do... Dans le forum PrusaSlicer	il y a 4 years
	I can say those scaling factors have been needed since I fir... Dans le forum PrusaSlicer	il y a 4 years
	default x,y scale factor? Dans le forum PrusaSlicer	il y a 4 years
	Very excellent. It looks like it took changing Pattern angle... Dans le forum Hardware, firmware and software help	il y a 4 years
	support.zip File attached. Dans le forum Hardware, firmware and software help	il y a 4 years
	Support Enforcers not working correctly (again) Dans le forum Hardware, firmware and software help	il y a 4 years
	I removed the block enforcer and used paint support, being c... Dans le forum Hardware, firmware and software help	il y a 4 years
	how to have support generated only from bottom to top of hol... Dans le forum Hardware, firmware and software help	il y a 4 years

Statistiques du forum

565 Forums

63.8 K Sujets

447.3 K Messages

20 En-ligne

69.3 K Membres

Le dernier des messages: Mk4S - is input shaping enabled? Notre nouveau membre: SilenceDIY Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé