Prusa3D Forum

Notifications

Clear all

Harlok67

Groupe: Enregistré

A(ont) rejoint: 2023/04/27

Active Member

	Buddycam settings? Where is it located? I can't find it anyw... Dans le forum Hardware, firmware and software help	il y a 5 months
	I understand that no one has tried to make multicolor prints... Dans le forum How do I print this? (Printing help)	il y a 9 months
	I know MMU printing well, so when I print TPU I use manual l... Dans le forum How do I print this? (Printing help)	il y a 9 months
	TPU is multi-color printing possible? Dans le forum How do I print this? (Printing help)	il y a 9 months
	I tried to do as you suggested...It works. You can see that ... Dans le forum How do I print this? (Printing help)	il y a 1 year
	Hi,. I was about to ask the exact same question. Did you hav... Dans le forum How do I print this? (Printing help)	il y a 1 year
	hello I also have trouble printing TPU.that's why I DON'T US... Dans le forum How do I print this? (Printing help)	il y a 1 year
	🤔 I hadn't thought of this solution..I want to try... Than... Dans le forum How do I print this? (Printing help)	il y a 1 year
	MMU3 and printing ABS or PC: is it possible?? Dans le forum How do I print this? (Printing help)	il y a 1 year
	Thanks for the reply,I also tried switching to expert mode. ... Dans le forum PrusaSlicer	il y a 3 years
	How to set print speed and acceleration in slicer? Dans le forum PrusaSlicer	il y a 3 years

Statistiques du forum

595 Forums

68.9 K Sujets

481.8 K Messages

13 En-ligne

77.5 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé