Prusa3D Forum

Notifications

Clear all

Harlok67

Skupina: Registrovaný

Přidal se: 2023/04/27

Active Member

	Buddycam settings? Where is it located? I can't find it anyw... In forum Hardware, firmware and software help	před 5 months
	I understand that no one has tried to make multicolor prints... In forum How do I print this? (Printing help)	před 8 months
	I know MMU printing well, so when I print TPU I use manual l... In forum How do I print this? (Printing help)	před 9 months
	TPU is multi-color printing possible? In forum How do I print this? (Printing help)	před 9 months
	I tried to do as you suggested...It works. You can see that ... In forum How do I print this? (Printing help)	před 1 year
	Hi,. I was about to ask the exact same question. Did you hav... In forum How do I print this? (Printing help)	před 1 year
	hello I also have trouble printing TPU.that's why I DON'T US... In forum How do I print this? (Printing help)	před 1 year
	🤔 I hadn't thought of this solution..I want to try... Than... In forum How do I print this? (Printing help)	před 1 year
	MMU3 and printing ABS or PC: is it possible?? In forum How do I print this? (Printing help)	před 1 year
	Thanks for the reply,I also tried switching to expert mode. ... In forum PrusaSlicer	před 3 years
	How to set print speed and acceleration in slicer? In forum PrusaSlicer	před 3 years

Fórum Statistiky

595 Fóra

68.8 K Témata

481.5 K Příspěvky

12 Online

77.4 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed