Prusa3D Forum

Notifications

Clear all

Harlok67

Grupa: Zarejestrowany

Dołączył: 2023/04/27

Active Member

	Buddycam settings? Where is it located? I can't find it anyw... In forum Hardware, firmware and software help	3 months temu
	I understand that no one has tried to make multicolor prints... In forum How do I print this? (Printing help)	6 months temu
	I know MMU printing well, so when I print TPU I use manual l... In forum How do I print this? (Printing help)	6 months temu
	TPU is multi-color printing possible? In forum How do I print this? (Printing help)	6 months temu
	I tried to do as you suggested...It works. You can see that ... In forum How do I print this? (Printing help)	1 year temu
	Hi,. I was about to ask the exact same question. Did you hav... In forum How do I print this? (Printing help)	1 year temu
	hello I also have trouble printing TPU.that's why I DON'T US... In forum How do I print this? (Printing help)	1 year temu
	🤔 I hadn't thought of this solution..I want to try... Than... In forum How do I print this? (Printing help)	1 year temu
	MMU3 and printing ABS or PC: is it possible?? In forum How do I print this? (Printing help)	1 year temu
	Thanks for the reply,I also tried switching to expert mode. ... In forum PrusaSlicer	2 years temu
	How to set print speed and acceleration in slicer? In forum PrusaSlicer	2 years temu

Statystyki Forum

585 Fora

67.9 K Tematy

476.1 K Posty

12 Online

75.5 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte