|
Thanks to you both. The bubbles have greatly diminished ove... In forum Hardware, firmware and software help |
1 year temu |
|
Smooth PEI Sheet Delaminated on First Print In forum Hardware, firmware and software help |
2 years temu |
|
I've tried tightening the spring and loosening it--the full ... In forum Hardware, firmware and software help |
3 years temu |
|
I got through a full 32-hour run with the Prusa green with n... In forum Hardware, firmware and software help |
3 years temu |
|
Filament Stops Feeding...but Only Prusa In forum Hardware, firmware and software help |
3 years temu |
|
A good thought. I checked those screws--they were not tight... In forum Hardware, firmware and software help |
5 years temu |
|
So it's still printing just fine. It's been going almost no... In forum Hardware, firmware and software help |
5 years temu |
|
Sounds good. I was at about 38 days when I ran into this pr... In forum Hardware, firmware and software help |
5 years temu |
|
Ah! Thanks to you both!I had previously moved the extruder ... In forum Hardware, firmware and software help |
5 years temu |
|
X-Axis Not Traveling Correct Distance In forum Hardware, firmware and software help |
5 years temu |
