|
Thanks to you both. The bubbles have greatly diminished ove... En el foro Hardware, firmware and software help |
hace 1 year |
|
Smooth PEI Sheet Delaminated on First Print En el foro Hardware, firmware and software help |
hace 2 years |
|
I've tried tightening the spring and loosening it--the full ... En el foro Hardware, firmware and software help |
hace 3 years |
|
I got through a full 32-hour run with the Prusa green with n... En el foro Hardware, firmware and software help |
hace 3 years |
|
Filament Stops Feeding...but Only Prusa En el foro Hardware, firmware and software help |
hace 3 years |
|
A good thought. I checked those screws--they were not tight... En el foro Hardware, firmware and software help |
hace 5 years |
|
So it's still printing just fine. It's been going almost no... En el foro Hardware, firmware and software help |
hace 5 years |
|
Sounds good. I was at about 38 days when I ran into this pr... En el foro Hardware, firmware and software help |
hace 5 years |
|
Ah! Thanks to you both!I had previously moved the extruder ... En el foro Hardware, firmware and software help |
hace 5 years |
|
X-Axis Not Traveling Correct Distance En el foro Hardware, firmware and software help |
hace 5 years |