Prusa3D Forum

Notifications

Clear all

hakan-1

Skupina: Registrovaný

Přidal se: 2020/01/18

New Member

	Found the source of the problem I think. There is some play ... In forum Assembly and first prints troubleshooting	před 5 years
	It is not an axial offset of the gear that is the problem, i... In forum Assembly and first prints troubleshooting	před 5 years
	Bad alignment of PTFE tube to bondtech gears In forum Assembly and first prints troubleshooting	před 5 years

Fórum Statistiky

565 Fóra

64 K Témata

448.4 K Příspěvky

21 Online

69.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed