|
1. This will very by filament. Some are worse than others. K... Dans le forum Others (Archive) |
il y a 7 years |
|
Try bumping your temps, slowing way down, and make sure the ... Dans le forum How do I print this? (Printing help) |
il y a 7 years |
|
When new versions of Slic3r are installed, the old profiles ... Dans le forum Others (Archive) |
il y a 7 years |
|
Flashed the 3.1.2-RC1 firmware and have run a couple smaller... Dans le forum Others (Archive) |
il y a 7 years |
|
Only time I adjust Z is when switching filament types. I als... Dans le forum Others (Archive) |
il y a 7 years |
|
I have yet to experience any performance issues effecting pr... Dans le forum Others (Archive) |
il y a 7 years |
|
I have ran my MK3 with both an external Pi2 and a Zero. The ... Dans le forum Others (Archive) |
il y a 7 years |
|
Great i will test that preset soon, for Vases and 0% infill ... Dans le forum Others (Archive) |
il y a 7 years |
|
The .35mm FAST profile is still available in Slic3r PE, if y... Dans le forum Others (Archive) |
il y a 7 years |
|
Agreed, there are still many situations where .3mm is viable... Dans le forum Others (Archive) |
il y a 7 years |
|
I have been having great luck with PETG, using the stock set... Dans le forum Others (Archive) |
il y a 7 years |
|
I am in total agreement with the original poster! The MK3 is... Dans le forum Others (Archive) |
il y a 7 years |
|
I will totally echo the sentiment that forums tend to sway h... Dans le forum Others (Archive) |
il y a 7 years |
|
I was just reading a few days ago that Ethyl Acetate (finger... Dans le forum Prusa i3 kit (Archive) |
il y a 7 years |
|
It should work just fine. That is what I did, pulled a RPi 2... Dans le forum Others (Archive) |
il y a 7 years |
|
On big open areas, where the printer can really open up on s... Dans le forum Others (Archive) |
il y a 7 years |
|
I had great luck with eSun eFlex TPU (Shore A 87). I just sl... Dans le forum Others (Archive) |
il y a 7 years |
|
For the belts, check the handbook, section 13.4.
When I ask... Dans le forum Others (Archive) |
il y a 7 years |
|
The defaults are pretty darn good!
I was communicating with... Dans le forum Others (Archive) |
il y a 7 years |
|
Yes. This is the Pi Zero W connected directly to the Einsy o... Dans le forum Others (Archive) |
il y a 7 years |
