Prusa3D Forum

Notifications

Clear all

Gyoenastaader

Groupe: Enregistré

A(ont) rejoint: 2025/08/03

Active Member

	Sure did, I pulled out the old MK3 motors to make sure I was... Dans le forum General discussion, announcements and releases	il y a 2 months
	The left side is empty. It looks just like the right side bu... Dans le forum General discussion, announcements and releases	il y a 2 months
	If you upgraded MK3>MK4>MK4S to a Core One, buy new motors Dans le forum General discussion, announcements and releases	il y a 2 months
	I solved the whine issue. It was the MK4 stepper motors. ... Dans le forum General discussion, announcements and releases	il y a 2 months
	For me, stealth mode does nothing. The motor whine and reson... Dans le forum General discussion, announcements and releases	il y a 2 months
	After talking with support for a good hour, and two videos l... Dans le forum General discussion, announcements and releases	il y a 2 months
	The issue I have is less the vibration of the printer, and m... Dans le forum General discussion, announcements and releases	il y a 2 months
	Tuned the belts, bought the accelerometer, ran input and pha... Dans le forum General discussion, announcements and releases	il y a 2 months

Statistiques du forum

585 Forums

68.5 K Sujets

479.5 K Messages

10 En-ligne

76.7 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé