|
I now have a couple of obXidian nozzles, and can answer my o... In forum General discussion, announcements and releases |
1 year ago |
|
All the Prusa Nextruder nozzles are made by E3D, no matter w... In forum Hardware, firmware and software help |
1 year ago |
|
With the latest firmware it is now finally possible to chang... In forum Input Shaper (MK4) |
1 year ago |
|
Posted by: @carlmmii It's my go-to for both 0.6mm and 0.4mm... In forum General discussion, announcements and releases |
2 years ago |
|
This is expected behaviour that is covered in the release no... In forum Input Shaper (MK4) |
2 years ago |
|
Thanks for your input, much appreciated! I would love to hea... In forum General discussion, announcements and releases |
2 years ago |
|
PrusaLink is only for access on your local network. PrusaCon... In forum General discussion, announcements and releases |
2 years ago |
|
Ok, that's fine, I was under the impression that didn't work... In forum Input Shaper (MK4) |
2 years ago |
|
The input shaper settings on the printer are still grayed ou... In forum Input Shaper (MK4) |
2 years ago |
|
ObXidian nozzles - how good are its non-stick properties? In forum General discussion, announcements and releases |
2 years ago |
|
Very interesting. Do you have a silicon sock on the heater b... In forum General discussion, announcements and releases |
2 years ago |
|
Never assume any filament is dry when it is new and just out... In forum General discussion, announcements and releases |
2 years ago |
|
On the Prusa Podcast on August 30th, Josef said it should be... In forum Input Shaper (MK4) |
2 years ago |
|
E3D claims the obxidian nozzles don't require additional tem... In forum Input Shaper (MK4) |
2 years ago |
|
I just finished assembling my MK4 yesterday and had this exa... In forum Assembly and first prints troubleshooting |
2 years ago |
|
Thanks for elaborating, I'm relieved to hear that VFA can be... In forum General discussion, announcements and releases |
2 years ago |
|
Thanks for sharing your findings Shushuda, much appreciated.... In forum General discussion, announcements and releases |
2 years ago |
