Prusa3D Forum

Notifications

Clear all

Greenhoe

Skupina: Registrovaný

Přidal se: 2020/12/22

Active Member

	Prusa Mini little layer gaps out of nowhere randomly on prin... In forum How do I print this? (Printing help)	před 4 years
	How to stop custom user preset print settings from auto savi... In forum PrusaSlicer	před 4 years
	Help getting consistent support underside for precision part In forum How do I print this? (Printing help)	před 4 years
	@ssill2 Adjusting the retraction has helped a lot! Thank you... In forum How do I print this? (Printing help)	před 5 years
	@ssill2 Thank you, I will test the retraction settings and s... In forum How do I print this? (Printing help)	před 5 years
	Possibly? Do you think I need to increase my retraction rate... In forum How do I print this? (Printing help)	před 5 years
	Little layer gaps randomly in prints on both my MK3S & MK3S+ In forum How do I print this? (Printing help)	před 5 years
	@bobstro I don't think so, under the printer settings which ... In forum Hardware, firmware and software help	před 5 years
	Stop Cura from auto unload filament after each print In forum Hardware, firmware and software help	před 5 years

Fórum Statistiky

585 Fóra

68.1 K Témata

477.4 K Příspěvky

10 Online

75.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed