|
@Snuffleupagus Thanks for being so kind in your reply. I ju... Dans le forum PrusaSlicer |
il y a 7 months |
|
Organic supports with gaps Dans le forum PrusaSlicer |
il y a 7 months |
|
I tried that and it would not move the folder. But I made a... Dans le forum General discussion, announcements and releases |
il y a 2 years |
|
I updated my models and I put the older STL's in a folder na... Dans le forum General discussion, announcements and releases |
il y a 2 years |
|
Thanks for the replies. That makes sense. Much appreciated... Dans le forum General discussion, announcements and releases |
il y a 2 years |
|
Correct way to post updated models on Printables Dans le forum General discussion, announcements and releases |
il y a 2 years |
|
That was it. Thanks so much!!! I never thought to check th... Dans le forum PrusaSlicer |
il y a 2 years |
|
Why does print speed change when object is consistently the ... Dans le forum PrusaSlicer |
il y a 2 years |
|
PrusaSlicer 2.4.0 and Configuration update Dans le forum PrusaSlicer |
il y a 3 years |
|
@swiss_cheese Thank you so much for taking the time to expla... Dans le forum PrusaSlicer |
il y a 3 years |
|
@swiss_cheese Thanks for all the information. It was very u... Dans le forum PrusaSlicer |
il y a 3 years |
|
@neophyl Thanks for the file. I may give this one a try. B... Dans le forum PrusaSlicer |
il y a 3 years |
|
Hello sylviatrilling, Thanks for the advice. I may give tha... Dans le forum PrusaSlicer |
il y a 3 years |
|
Thanks Neophyl,
I realize I did not state that I was using... Dans le forum PrusaSlicer |
il y a 3 years |
|
Support question in 2.4.0 RC2 Dans le forum PrusaSlicer |
il y a 3 years |
|
I just left a reply on another post about power cords. I ju... Dans le forum Others (Archive) |
il y a 5 years |
|
What is the draw of the device? I have built an enclosure a... Dans le forum Hardware, firmware and software help |
il y a 5 years |
|
Hi,
what are the pro's and con's of turning on/off magnet co... Dans le forum General discussion, announcements and releases |
il y a 6 years |
|
I finally see a listing on Amazon but no availability yet so... Dans le forum General discussion, announcements and releases |
il y a 6 years |
|
Ok then I understand.
Your X-carriage back on the extruder i... Dans le forum Assembly and first prints troubleshooting |
il y a 6 years |
