Prusa3D Forum

Notifications

Clear all

Glenn

Groupe: Enregistré

A(ont) rejoint: 2021/05/22

Active Member

	At least the support admitted that the Prusament isn’t neces... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	I'm still not able to get a good top layer with this printer... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	@cwbullet Yes. I think I'll raise the Pinda a bit more. But ... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	Top layers are under-extruded, prints otherwise look good an... Dans le forum Assembly and first prints troubleshooting	il y a 3 years
	I reassembled the extruder, and made sure to push the gears ... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	Okey, I’ve figured it out; If your extruder gears (not filam... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	There are no grind marks and no issues with the filament. It... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	It’s very apparent from 00:02-00:03, a scratching noise when... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	"Oink-oink" grinding noise from extruder on retraction with ... Dans le forum Assembly and first prints troubleshooting	il y a 4 years

Statistiques du forum

559 Forums

63.1 K Sujets

443.8 K Messages

21 En-ligne

68.1 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé