Prusa3D Forum

Notifications

Clear all

Glenn

Skupina: Registrovaný

Přidal se: 2021/05/22

Active Member

	At least the support admitted that the Prusament isn’t neces... In forum Assembly and first prints troubleshooting	před 3 years
	I'm still not able to get a good top layer with this printer... In forum Assembly and first prints troubleshooting	před 3 years
	@cwbullet Yes. I think I'll raise the Pinda a bit more. But ... In forum Assembly and first prints troubleshooting	před 3 years
	Top layers are under-extruded, prints otherwise look good an... In forum Assembly and first prints troubleshooting	před 3 years
	I reassembled the extruder, and made sure to push the gears ... In forum Assembly and first prints troubleshooting	před 4 years
	Okey, I’ve figured it out; If your extruder gears (not filam... In forum Assembly and first prints troubleshooting	před 4 years
	There are no grind marks and no issues with the filament. It... In forum Assembly and first prints troubleshooting	před 4 years
	It’s very apparent from 00:02-00:03, a scratching noise when... In forum Assembly and first prints troubleshooting	před 4 years
	"Oink-oink" grinding noise from extruder on retraction with ... In forum Assembly and first prints troubleshooting	před 4 years

Fórum Statistiky

566 Fóra

63.2 K Témata

444.2 K Příspěvky

25 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed