Prusa3D Forum

Notifications

Clear all

giannis.f

Skupina: Registrovaný

Přidal se: 2016/06/17

Active Member

	X Y steps In forum Hardware, firmware and software help	před 5 years
	Hi Joan, Thank you for your reply 🙂 I checked the hotend... In forum Hardware, firmware and software help	před 6 years
	Cannot find the reasons of clogging In forum Hardware, firmware and software help	před 6 years
	Infill is visible on the outer perimeter CURA In forum Hardware, firmware and software help	před 7 years
	0.025? wow thats huge difference! I will try to lower the no... In forum Print tips (Archive)	před 8 years
	I think that my Z live adjust is fine. If I lower more the n... In forum Print tips (Archive)	před 8 years
	Hello Peter thank you for the try! Also I am very sorry for ... In forum Print tips (Archive)	před 8 years
	Hey Peter of course I can. Here you are Christophe I thin... In forum Print tips (Archive)	před 8 years
	Hey Nicholas So if i print with 55 degrees things will be be... In forum Print tips (Archive)	před 8 years
	Hey Peter, did that too. I tried IPA and Acetone but none wo... In forum Print tips (Archive)	před 8 years
	Hey Peter thanks for your reply. I have tried a big part wit... In forum Print tips (Archive)	před 8 years
	Big problem with Warping - PLA In forum Print tips (Archive)	před 8 years

Fórum Statistiky

565 Fóra

63.6 K Témata

446 K Příspěvky

21 Online

68.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed