Notifiche
Cancella tutti
ghostrider13
Gruppo: Registrato
Registrato: 2023/05/02
Active Member
1
| Installed 6.3.3 - Z-axis issues still present with stock G-c... | 7 months fa | |
| > After reading this thread I tried a print and turned th... | 7 months fa | |
| Apologies. I meant 3 lead screws.Prusa support advised follo... | 9 months fa | |
| Z axis trouble but only when printing | 9 months fa | |
|
Tried the same model again 5.1.0-beta firmware and 2.7.0-rc1... Nel forum Input Shaper (MK4) |
2 years fa | |
|
5.1.0-beta firmware fixed the issue for me. Nel forum Input Shaper (MK4) |
2 years fa | |
| Octoprint Bed Leveling Mesh plugin | 2 years fa | |
| Factory assembled 5 tool XL. Fails bed leveling.Support advi... | 2 years fa | |
|
MK4 layer shifts on the X axis after installing 5.1.0-alpha2 Nel forum Hardware, firmware and software help |
2 years fa | |
|
This has got to be a firmware issue. I just installed 5.1-al... Nel forum Input Shaper (MK4) |
2 years fa | |
|
Artifacts on PETG printed part Nel forum Input Shaper (MK4) |
3 years fa | |
|
Yes. Seeing this too, along with message "Y axis homing fail... Nel forum Input Shaper (MK4) |
3 years fa |