Gavin – Aktivität – Prusa3D Forum

Benachrichtigungen

Alles löschen

Gavin

Gruppe: Registriert

Beigetreten: 2017/06/03

Eminent Member

	Infill lifting near perimeters. Im Forum Hardware, firmware and software help	Vor 7 years
	How did you go? Im Forum Others (Archive)	Vor 7 years
	I suppose so, but then my question is, why would resume star... Im Forum Hardware, firmware and software help	Vor 7 years
	LCD control bugs? Im Forum Hardware, firmware and software help	Vor 7 years
	When building my printer I noticed one of my cable ties was ... Im Forum General discussion, announcements and releases	Vor 7 years
	Yes Joan, I will do the same prints again at some point. D... Im Forum Hardware, firmware and software help	Vor 7 years
	The final result: Does everyone else have t... Im Forum Hardware, firmware and software help	Vor 7 years
	Thankyou all. My issues were indeed with layer height. Pic... Im Forum Hardware, firmware and software help	Vor 7 years
	Bottom to top:Before detergent, after detergent, and then +1... Im Forum Hardware, firmware and software help	Vor 7 years
	Another angle Im Forum Hardware, firmware and software help	Vor 7 years
	Some examples with +10C. I’m happy with these prints. Is th... Im Forum Hardware, firmware and software help	Vor 7 years
	Try washing the buildplate with washing up liquid and water ... Im Forum Hardware, firmware and software help	Vor 7 years
	I have to increase nozzle temp +10C to get supplied sdcard g... Im Forum Hardware, firmware and software help	Vor 7 years

Seite 2 / 2 Vorherige

Forums-Statistiken

565 Foren

63.5 K Themen

446 K Beiträge

21 Online

68.8 K Mitglieder

Forum Icons: Das Forum enthält keine ungelesenen Beiträge Das Forum enthält ungelesene Beiträge

Themen-Icons: Unbeantwortet Beantwortet Aktiv Heiß Oben angepinnt Nicht genehmigt Gelöst Privat Geschlossen