Gavin – Aktivita – Prusa3D Forum

Notifications

Clear all

Gavin

Skupina: Registrovaný

Přidal se: 2017/06/03

Eminent Member

	Infill lifting near perimeters. In forum Hardware, firmware and software help	před 7 years
	How did you go? In forum Others (Archive)	před 7 years
	I suppose so, but then my question is, why would resume star... In forum Hardware, firmware and software help	před 7 years
	LCD control bugs? In forum Hardware, firmware and software help	před 7 years
	When building my printer I noticed one of my cable ties was ... In forum General discussion, announcements and releases	před 7 years
	Yes Joan, I will do the same prints again at some point. D... In forum Hardware, firmware and software help	před 7 years
	The final result: Does everyone else have t... In forum Hardware, firmware and software help	před 7 years
	Thankyou all. My issues were indeed with layer height. Pic... In forum Hardware, firmware and software help	před 7 years
	Bottom to top:Before detergent, after detergent, and then +1... In forum Hardware, firmware and software help	před 7 years
	Another angle In forum Hardware, firmware and software help	před 7 years
	Some examples with +10C. I’m happy with these prints. Is th... In forum Hardware, firmware and software help	před 7 years
	Try washing the buildplate with washing up liquid and water ... In forum Hardware, firmware and software help	před 7 years
	I have to increase nozzle temp +10C to get supplied sdcard g... In forum Hardware, firmware and software help	před 7 years

Stránka 2 / 2 Předchozí

Fórum Statistiky

565 Fóra

63.5 K Témata

446 K Příspěvky

22 Online

68.8 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed