Gavin – Activité – Prusa3D Forum

Notifications

Clear all

Gavin

Groupe: Enregistré

A(ont) rejoint: 2017/06/03

Eminent Member

	Infill lifting near perimeters. Dans le forum Hardware, firmware and software help	il y a 7 years
	How did you go? Dans le forum Others (Archive)	il y a 7 years
	I suppose so, but then my question is, why would resume star... Dans le forum Hardware, firmware and software help	il y a 7 years
	LCD control bugs? Dans le forum Hardware, firmware and software help	il y a 7 years
	When building my printer I noticed one of my cable ties was ... Dans le forum General discussion, announcements and releases	il y a 7 years
	Yes Joan, I will do the same prints again at some point. D... Dans le forum Hardware, firmware and software help	il y a 7 years
	The final result: Does everyone else have t... Dans le forum Hardware, firmware and software help	il y a 7 years
	Thankyou all. My issues were indeed with layer height. Pic... Dans le forum Hardware, firmware and software help	il y a 7 years
	Bottom to top:Before detergent, after detergent, and then +1... Dans le forum Hardware, firmware and software help	il y a 7 years
	Another angle Dans le forum Hardware, firmware and software help	il y a 7 years
	Some examples with +10C. I’m happy with these prints. Is th... Dans le forum Hardware, firmware and software help	il y a 7 years
	Try washing the buildplate with washing up liquid and water ... Dans le forum Hardware, firmware and software help	il y a 7 years
	I have to increase nozzle temp +10C to get supplied sdcard g... Dans le forum Hardware, firmware and software help	il y a 7 years

Page 2 / 2 Précédent

Statistiques du forum

565 Forums

63.7 K Sujets

446.9 K Messages

22 En-ligne

69.3 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé