Avisos
Vaciar todo
Gatze
Grupo: Registrado
Registrado: 2021/12/11
Active Member
1
|
First | Initial Layer flow En el foro PrusaSlicer |
hace 4 years | |
|
Found the answer, important to know for calibration of the e... En el foro PrusaSlicer |
hace 4 years | |
|
Is there overlap between lines in the walls/perimeters ? En el foro PrusaSlicer |
hace 4 years | |
|
Thank you, the thin walls detection was checked, this is wit... En el foro PrusaSlicer |
hace 4 years | |
|
Hole in slicing model, how to solve ? En el foro PrusaSlicer |
hace 4 years |