Notifications
Clear all
Gatze
Group: Registered
Joined: 2021/12/11
Active Member
1
|
First | Initial Layer flow In forum PrusaSlicer |
4 years ago | |
|
Found the answer, important to know for calibration of the e... In forum PrusaSlicer |
4 years ago | |
|
Is there overlap between lines in the walls/perimeters ? In forum PrusaSlicer |
4 years ago | |
|
Thank you, the thin walls detection was checked, this is wit... In forum PrusaSlicer |
4 years ago | |
|
Hole in slicing model, how to solve ? In forum PrusaSlicer |
4 years ago |