Notifications
Clear all
galalumiere
Skupina: Registrovaný
Přidal se: 2019/10/29
Active Member
1
|
Hello I have the exact same problem! And whenever I try the ... In forum Hardware, firmware and software help |
před 5 years | |
| My einsy board is a 1.1b if this helps as well | před 5 years | |
| Y axis | před 5 years | |
| Also whenever I try to selftest the printer everything works... | před 5 years | |
| First Layer Calibration Y axis not moving | před 5 years | |
| MMU2 Pulley Motor spinning in wrong direction when loading f... | před 5 years | |
| @trent-t I had the wiring that connects the mmu2 to the prin... | před 5 years | |
| MMU2s feeding problems | před 5 years |