MMU2 Pulley Motor spinning in wrong direction when loading filament
 
Notifications
Clear all

MMU2 Pulley Motor spinning in wrong direction when loading filament  

  RSS
galalumiere
(@galalumiere)
Active Member
MMU2 Pulley Motor spinning in wrong direction when loading filament

Hello I recently set up my MMU2s upgrade on my mk3 printer and when I go to load filament and when I load filament to the nozzle, the pulley motor spins the wrong direction and wont advance any of the material. When I push load filament then load all it goes through all 5 filaments like it is properly loaded when it is not. 

Posted : 30/10/2019 2:02 pm
Share: