Notifiche
Cancella tutti
Fred
Gruppo: Registrato
Registrato: 2023/10/29
Active Member
1
|
Would like to thank everyone for their support Fred Nel forum Hardware, firmware and software help |
2 years fa | |
|
I have adjusted the Z to -0.400 and the prints as the pictur... Nel forum Hardware, firmware and software help |
2 years fa | |
|
This is a picture of calibration. Done the firmware update t... Nel forum Hardware, firmware and software help |
2 years fa | |
|
Will do that before the chat. Thanks again Fred Nel forum Hardware, firmware and software help |
2 years fa | |
|
I just done the cal that was in the firmware update Fred Nel forum Hardware, firmware and software help |
2 years fa | |
|
Thanks for your time and trouble Fred Nel forum Hardware, firmware and software help |
2 years fa | |
|
I am on 3.13.1. It did not do this before the upgrade but I... Nel forum Hardware, firmware and software help |
2 years fa | |
|
thermal error Nel forum Hardware, firmware and software help |
2 years fa |