Notifications
Clear all
Fred
Groupe: Enregistré
A(ont) rejoint: 2023/10/29
Active Member
1
|
Would like to thank everyone for their support Fred Dans le forum Hardware, firmware and software help |
il y a 1 year | |
|
I have adjusted the Z to -0.400 and the prints as the pictur... Dans le forum Hardware, firmware and software help |
il y a 1 year | |
|
This is a picture of calibration. Done the firmware update t... Dans le forum Hardware, firmware and software help |
il y a 1 year | |
|
Will do that before the chat. Thanks again Fred Dans le forum Hardware, firmware and software help |
il y a 1 year | |
|
I just done the cal that was in the firmware update Fred Dans le forum Hardware, firmware and software help |
il y a 1 year | |
|
Thanks for your time and trouble Fred Dans le forum Hardware, firmware and software help |
il y a 1 year | |
|
I am on 3.13.1. It did not do this before the upgrade but I... Dans le forum Hardware, firmware and software help |
il y a 1 year | |
|
thermal error Dans le forum Hardware, firmware and software help |
il y a 1 year |