Čeština
Fóra
Uživatelé
fordville
Aktivita
 
Notifications
Clear all
fordville
fordville
Skupina: Registrovaný
Přidal se: 2022/12/15
Active Member
1
Profile Aktivita
Maybe I'm getting closer. Below is the first layer of this ...

In forum Assembly and first prints troubleshooting

 před 2 years
RE: Brim or no brim

In forum Assembly and first prints troubleshooting

 před 2 years
Thank you and I agree. I've continued to adjust this. I've...

In forum Assembly and first prints troubleshooting

 před 2 years
Not the optimal color for a photo of this, but this run was ...

In forum Assembly and first prints troubleshooting

 před 2 years
I did some experimentation using the glue stick and that is ...

In forum Assembly and first prints troubleshooting

 před 2 years
I have run that and the 3x3 test many, many times. I get ni...

In forum Assembly and first prints troubleshooting

 před 2 years
Brim or no brim

In forum Assembly and first prints troubleshooting

 před 2 years
My issue (that gave similar globbing results) was the nozzle...

In forum Assembly and first prints troubleshooting

 před 2 years
Hooray for small victories!

In forum Assembly and first prints troubleshooting

 před 2 years
These look good to me! I'm about where you are in the hobby...

In forum Assembly and first prints troubleshooting

 před 2 years
Thank you! I was wondering if there were any other potentia...

In forum Assembly and first prints troubleshooting

 před 2 years
Ah! In taking off the fan and shroud, I could not detect a ...

In forum Assembly and first prints troubleshooting

 před 2 years
Thank you, I'll will inspect these parts. I do remember the ...

In forum Assembly and first prints troubleshooting

 před 2 years
Over-extrusion - seems to come and go

In forum Assembly and first prints troubleshooting

 před 2 years
Strings on a small object

In forum How do I print this? (Printing help)

 před 2 years
Share: