Notifications
Clear all
FocusOnTheSun
FocusOnTheSun
Skupina: Registrovaný
Přidal se: 2022/06/06
Eminent Member
2
Thanks for the help! I'll try giving drying the filament a g...

In forum How do I print this? (Printing help)

před 11 months
Turns out it was some dodgy print settings applied by someon...

In forum How do I print this? (Printing help)

před 11 months
Why are my prints turning out blotchy and brown?

In forum How do I print this? (Printing help)

před 11 months
Heya! I've attached the file below, cheers!  71f907cc...

In forum How do I print this? (Printing help)

před 11 months
Model on model supports not adhering

In forum How do I print this? (Printing help)

před 11 months
TPU overhang layering artifacts

In forum How do I print this? (Printing help)

před 12 months
Really appreciate all the detailed insights guys - I'll do s...

In forum How do I print this? (Printing help)

před 2 years
Printing TPU on the MK4

In forum How do I print this? (Printing help)

před 2 years
High temperature filament MAX TEMP reached failure

In forum How do I print this? (Printing help)

před 2 years
Just want to post on this thread with an update - I wasn't f...

In forum How do I print this? (Printing help)

před 2 years
That's very clever! I appreciate the advice, I will definite...

In forum Hardware, firmware and software help

před 2 years
Printer X axis rattle

In forum Hardware, firmware and software help

před 2 years
Flexible filament fails at consistent intervals

In forum How do I print this? (Printing help)

před 2 years
Can confirm, nozzle replacement seemed to do the trick! I st...

In forum Hardware, firmware and software help

před 2 years
I haven't tried that yet - do you reckon that could be a cau...

In forum Hardware, firmware and software help

před 2 years
Flexible filament no longer loading

In forum Hardware, firmware and software help

před 2 years
Update, if I press down slightly on the bed the rattling noi...

In forum Hardware, firmware and software help

před 2 years
Printer bed rattling noise

In forum Hardware, firmware and software help

před 2 years
I appreciate the response! But forgive me, I still can't e...

In forum How do I print this? (Printing help)

před 2 years
Fair enough yeah I wouldn't put too much weight behind the v...

In forum How do I print this? (Printing help)

před 2 years
Stránka 1 / 2
Share: