Prusa3D Forum

Notifications

Clear all

flyhawk

Groupe: Enregistré

A(ont) rejoint: 2017/11/02

Active Member

	Hi Guys, I was a little bit quiet for some time. I did a sev... Dans le forum Hardware, firmware and software help	il y a 6 years
	Isopropanol help only temporary... I use a few detergent and... Dans le forum Hardware, firmware and software help	il y a 6 years
	What kind of detergent would you recomend? Isopropanol works... Dans le forum Hardware, firmware and software help	il y a 6 years
	Today arrived new spool of the same PET-G. Well it is better... Dans le forum Hardware, firmware and software help	il y a 6 years
	Hi , I clean sheet several times. Unfortunately, it didn't ... Dans le forum Hardware, firmware and software help	il y a 6 years
	Will try to do so... Hopefully will helps. So far I print se... Dans le forum Hardware, firmware and software help	il y a 6 years
	I try to do so, but it didn't help. Still didn't stay on pla... Dans le forum Hardware, firmware and software help	il y a 6 years
	Wrong first layer or? Dans le forum Hardware, firmware and software help	il y a 6 years
	Slicer PE - gaps small perimeters Dans le forum Print tips (Archive)	il y a 7 years

Statistiques du forum

559 Forums

62.9 K Sujets

442.8 K Messages

19 En-ligne

67.6 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé