Prusa3D Forum

Notifications

Clear all

flyhawk

Skupina: Registrovaný

Přidal se: 2017/11/02

Active Member

	Hi Guys, I was a little bit quiet for some time. I did a sev... In forum Hardware, firmware and software help	před 6 years
	Isopropanol help only temporary... I use a few detergent and... In forum Hardware, firmware and software help	před 6 years
	What kind of detergent would you recomend? Isopropanol works... In forum Hardware, firmware and software help	před 6 years
	Today arrived new spool of the same PET-G. Well it is better... In forum Hardware, firmware and software help	před 6 years
	Hi , I clean sheet several times. Unfortunately, it didn't ... In forum Hardware, firmware and software help	před 6 years
	Will try to do so... Hopefully will helps. So far I print se... In forum Hardware, firmware and software help	před 6 years
	I try to do so, but it didn't help. Still didn't stay on pla... In forum Hardware, firmware and software help	před 6 years
	Wrong first layer or? In forum Hardware, firmware and software help	před 6 years
	Slicer PE - gaps small perimeters In forum Print tips (Archive)	před 7 years

Fórum Statistiky

567 Fóra

64.8 K Témata

453.7 K Příspěvky

22 Online

71.7 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed