Prusa3D Forum

Notifications

Clear all

flyhawk

Group: Registered

Joined: 2017/11/02

Active Member

	Hi Guys, I was a little bit quiet for some time. I did a sev... In forum Hardware, firmware and software help	6 years ago
	Isopropanol help only temporary... I use a few detergent and... In forum Hardware, firmware and software help	6 years ago
	What kind of detergent would you recomend? Isopropanol works... In forum Hardware, firmware and software help	6 years ago
	Today arrived new spool of the same PET-G. Well it is better... In forum Hardware, firmware and software help	6 years ago
	Hi , I clean sheet several times. Unfortunately, it didn't ... In forum Hardware, firmware and software help	6 years ago
	Will try to do so... Hopefully will helps. So far I print se... In forum Hardware, firmware and software help	6 years ago
	I try to do so, but it didn't help. Still didn't stay on pla... In forum Hardware, firmware and software help	6 years ago
	Wrong first layer or? In forum Hardware, firmware and software help	6 years ago
	Slicer PE - gaps small perimeters In forum Print tips (Archive)	7 years ago

Forum Statistics

559 Forums

62.9 K Topics

442.8 K Posts

21 Online

67.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed