flux_capacitor – Aktivita

Notifications

Clear all

flux_capacitor

Skupina: PrusaLink-beta

Přidal se: 2018/10/26

Název: Member

	My hypothesis: during printing, I can see that for the longe... In forum How do I print this? (Printing help)	před 4 years
	How to avoid these hollow lines (underextrusion?) In forum How do I print this? (Printing help)	před 4 years
	I finally tried the kitchen oven thing. 4 hours @ 40 °C. Pri... In forum How do I print this? (Printing help)	před 7 years
	Apparently this would be caused by various factors, the wors... In forum How do I print this? (Printing help)	před 7 years
	I think too there may be a problem with the filament materia... In forum How do I print this? (Printing help)	před 7 years
	Thanks for your answer Curtis! I thought of a jam too so I u... In forum How do I print this? (Printing help)	před 7 years
	Good translucent flex suddenly becomes milky-white foam In forum How do I print this? (Printing help)	před 7 years

Stránka 2 / 2 Předchozí

Fórum Statistiky

585 Fóra

68.2 K Témata

477.8 K Příspěvky

11 Online

75.9 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed