Aktywność
 
Notifications
Clear all
FerTech
FerTech
Grupa: Zarejestrowany
Dołączył: 2020/04/11
Trusted Member
3
@txema Hi, I did that, checked the temperature of the enclos...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years temu
Thanks a lot for your comments and help. I was able to get g...

In forum Assembly and first prints troubleshooting

4 years temu
Thanks a lot for your comments. I will give it a try again a...

In forum Assembly and first prints troubleshooting

4 years temu
I dont get it, Z calibration works great, print fails

In forum Assembly and first prints troubleshooting

4 years temu
Hi there, thank you for sharing, yes, I used a similar meth...

In forum How do I print this? (Printing help)

4 years temu
Folks, wanted to report back that the print finished very ni...

In forum How do I print this? (Printing help)

4 years temu
Thanks for the tips folks! I am adjusting Z and I was defini...

In forum How do I print this? (Printing help)

4 years temu
Another update, third try also failed, this time even more a...

In forum How do I print this? (Printing help)

4 years temu
Cant seem to get this right - Tesla Cybertruck print

In forum How do I print this? (Printing help)

4 years temu
I asked support some days back and here is their answer: To ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years temu
@halcon-designs Ok, so I am buying the parts to build the dr...

In forum How do I print this? (Printing help)

4 years temu
@halcon-designs Again, thanks a lot! Will have to try with i...

In forum How do I print this? (Printing help)

4 years temu
@halcon-designs Thanks for sharing, lovely box, looks like t...

In forum How do I print this? (Printing help)

4 years temu
@halcon-designs Hi there, this would be quite unrealistic, I...

In forum How do I print this? (Printing help)

4 years temu
I tested these settings and the results seem to be worse tha...

In forum How do I print this? (Printing help)

4 years temu
Do the above parameters look ok to you?

In forum How do I print this? (Printing help)

4 years temu
@halcon-designs 👍 now it works 😉 I swear I tried to search ...

In forum How do I print this? (Printing help)

4 years temu
I am a bit confused, Its probably a rookie question, but how...

In forum How do I print this? (Printing help)

4 years temu
@halcon-designs Thanks! So for now, should I completely turn...

In forum How do I print this? (Printing help)

4 years temu
@halcon-designs Here some more images: Here while it was pri...

In forum How do I print this? (Printing help)

4 years temu
Strona 2 / 5
Share: