Prusa3D Forum

Notifications

Clear all

excel

Skupina: Registrovaný

Přidal se: 2024/07/02

New Member

	I did not replace the tube, but I did inspect it, it was in ... In forum Hardware, firmware and software help	před 5 months
	Thanks for the suggestions. I was running the same 4.2.1 fir... In forum Hardware, firmware and software help	před 5 months
	More failure modes, Some straight walls on edge of print are... In forum Hardware, firmware and software help	před 5 months
	After years of clean prints, suddenly terrible overhangs and... In forum Hardware, firmware and software help	před 5 months

Fórum Statistiky

566 Fóra

63.2 K Témata

444.6 K Příspěvky

22 Online

68.2 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed