Prusa3D Forum

Notifications

Clear all

excel

Group: Registered

Joined: 2024/07/02

New Member

	I did not replace the tube, but I did inspect it, it was in ... In forum Hardware, firmware and software help	5 months ago
	Thanks for the suggestions. I was running the same 4.2.1 fir... In forum Hardware, firmware and software help	5 months ago
	More failure modes, Some straight walls on edge of print are... In forum Hardware, firmware and software help	5 months ago
	After years of clean prints, suddenly terrible overhangs and... In forum Hardware, firmware and software help	5 months ago

Forum Statistics

566 Forums

63.2 K Topics

444.5 K Posts

23 Online

68.2 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed