Notifications
Clear all
erwin.b
Grupa: Zarejestrowany
Dołączył: 2016/08/22
Active Member
1
|
Hi Peter, I use a 1mm Z hop in Cura, that's the same right?
... In forum Others (Archive) |
8 years temu | |
|
Can't print with supports In forum Others (Archive) |
8 years temu | |
|
Bubbly edges In forum Others (Archive) |
8 years temu | |
|
Ok so installed the new fan, re-adjusted the z-axis like Dav... In forum Prusa i3 kit (Archive) |
8 years temu | |
|
Thanks again David.
I tried everything you suggested, but th... In forum Prusa i3 kit (Archive) |
8 years temu | |
|
The little one does, it starts spinning at 50 degrees.
How d... In forum Prusa i3 kit (Archive) |
8 years temu | |
|
Hi david, thanks for your advice so far.
I have tried moving... In forum Prusa i3 kit (Archive) |
8 years temu | |
|
I added a picture of the first layer of the prusa logo.
Also... In forum Prusa i3 kit (Archive) |
8 years temu | |
|
Adalinda leg breaking off In forum Prusa i3 kit (Archive) |
8 years temu |