Notifications
Clear all
erwin.b
Groupe: Enregistré
A(ont) rejoint: 2016/08/22
Active Member
1
|
Hi Peter, I use a 1mm Z hop in Cura, that's the same right?
... Dans le forum Others (Archive) |
il y a 8 years | |
|
Can't print with supports Dans le forum Others (Archive) |
il y a 8 years | |
|
Bubbly edges Dans le forum Others (Archive) |
il y a 8 years | |
|
Ok so installed the new fan, re-adjusted the z-axis like Dav... Dans le forum Prusa i3 kit (Archive) |
il y a 8 years | |
|
Thanks again David.
I tried everything you suggested, but th... Dans le forum Prusa i3 kit (Archive) |
il y a 8 years | |
|
The little one does, it starts spinning at 50 degrees.
How d... Dans le forum Prusa i3 kit (Archive) |
il y a 8 years | |
|
Hi david, thanks for your advice so far.
I have tried moving... Dans le forum Prusa i3 kit (Archive) |
il y a 8 years | |
|
I added a picture of the first layer of the prusa logo.
Also... Dans le forum Prusa i3 kit (Archive) |
il y a 8 years | |
|
Adalinda leg breaking off Dans le forum Prusa i3 kit (Archive) |
il y a 8 years |