Avisos
Vaciar todo
erwin.b
Grupo: Registrado
Registrado: 2016/08/22
Active Member
1
|
Hi Peter, I use a 1mm Z hop in Cura, that's the same right?
... En el foro Others (Archive) |
hace 9 years | |
|
Can't print with supports En el foro Others (Archive) |
hace 9 years | |
|
Bubbly edges En el foro Others (Archive) |
hace 9 years | |
|
Ok so installed the new fan, re-adjusted the z-axis like Dav... En el foro Prusa i3 kit (Archive) |
hace 9 years | |
|
Thanks again David.
I tried everything you suggested, but th... En el foro Prusa i3 kit (Archive) |
hace 9 years | |
|
The little one does, it starts spinning at 50 degrees.
How d... En el foro Prusa i3 kit (Archive) |
hace 9 years | |
|
Hi david, thanks for your advice so far.
I have tried moving... En el foro Prusa i3 kit (Archive) |
hace 9 years | |
|
I added a picture of the first layer of the prusa logo.
Also... En el foro Prusa i3 kit (Archive) |
hace 9 years | |
|
Adalinda leg breaking off En el foro Prusa i3 kit (Archive) |
hace 9 years |