Notifications
Clear all
Erik
Skupina: Registrovaný
Přidal se: 2024/01/19
Active Member
1
| Quality is the reason I use this site. There should be a rul... | před 7 months | |
| Awesome! It will also come with PMS. Prusa Material System.... | před 7 months | |
| I can only share my experience, not give a definitive answer... | před 10 months | |
| Thanks! That is a good idea! I´ll try that | před 10 months | |
| Sorry for late response (sleep and work got in the way 🙂 ),... | před 10 months | |
| Should I change the silica desiccant in my filament dryer? | před 10 months | |
| I started with a few toys and fidgets, and then stuff for my... | před 10 months | |
| Just a thought, but you could check out the YouTube channel ... | před 11 months | |
| I have the same issue. It is hard to get downloads, even wi... | před 2 years | |
|
Have you checked out slicing tolerances in Cura? Worth havin... In forum Cura, Simplify3D, Kisslicer, ... |
před 2 years | |
| Publish your model, and press the button on the model page. ... | před 2 years |