Notifications
Clear all
Eric Mathison
Eric Mathison
Grupa: Zarejestrowany
Dołączył: 2018/05/30
Active Member
1
Tim, everything works on the board except the Z-axis. Would ...

In forum Hardware, firmware and software help

5 years temu
Z-axis not working

In forum Hardware, firmware and software help

5 years temu
I'd like to thank you for all of your efforts and informatio...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
What would be a good belt tension gauge to use? Would someth...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
Just for the record, I'm experiencing the same issues as oth...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
Does the 0.9-Degree-Stepper-Support branch have support for ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
Doing a full reset worked. Thanks.

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
After installing Moons 0.9 motors on the X & Y axis, alo...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
I was in the MK3 branch by mistake. I switched to the LA15 a...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
Having trouble compiling on Windows: eeprom.h:221:1: error: ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
BTW, don't forget to add heatsinks to the TMC2130's if using...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 years temu
Hi Joan, Thanks for the detailed instructions! I ordered s...

In forum General discussion, announcements and releases

6 years temu
Thanks for the quick reply. But, I'm not too sure how I'd go...

In forum General discussion, announcements and releases

6 years temu
Extruder squeaking caused by PTFE tube?

In forum General discussion, announcements and releases

6 years temu
I made sure that the U-bolts on the Y carriage bearings were...

In forum General discussion, announcements and releases

6 years temu
MK3 louder than expected

In forum General discussion, announcements and releases

6 years temu
Share: