Prusa3D Forum

Notifications

Clear all

Eric Mackrodt

Groupe: Enregistré

A(ont) rejoint: 2022/03/05

Active Member

	So, I have replaced the smooth bars and bearings, and the wa... Dans le forum Hardware, firmware and software help	il y a 3 years
	I have purchased the rods, bearings and 2x5g lubricant strai... Dans le forum Hardware, firmware and software help	il y a 3 years
	Hi @Diem, thanks for getting back to me.The seller said that... Dans le forum Hardware, firmware and software help	il y a 3 years
	For some reason I couldn't post images on the post again. He... Dans le forum Hardware, firmware and software help	il y a 3 years
	Hi @diem, I finally had some time to disassemble the printer... Dans le forum Hardware, firmware and software help	il y a 3 years
	Thanks for the response,It's really hard to tell if the axis... Dans le forum Hardware, firmware and software help	il y a 3 years
	I'm posting the images again because it seems like they are ... Dans le forum Hardware, firmware and software help	il y a 3 years
	MK3s with Bondtech Extruder issues with quality of walls and... Dans le forum Hardware, firmware and software help	il y a 3 years

Statistiques du forum

565 Forums

63.6 K Sujets

446.2 K Messages

21 En-ligne

68.9 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé