Prusa3D Forum

Notifications

Clear all

Epik

Grupa: Zarejestrowany

Dołączył: 2018/02/17

New Member

	Doh! And here I thought I was just slow at getting the setti... In forum Hardware, firmware and software help	6 years temu
	The surface temperature when set to 85 varies from 45 on the... In forum Hardware, firmware and software help	6 years temu
	I'll try to snap a photo when it happens again. The PETG par... In forum Hardware, firmware and software help	6 years temu
	PEI spring sheet lifting off the print bed In forum Hardware, firmware and software help	6 years temu

Statystyki Forum

566 Fora

63.2 K Tematy

444.4 K Posty

21 Online

68.1 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte