Prusa3D Forum

Notifications

Clear all

Epik

Skupina: Registrovaný

Přidal se: 2018/02/17

New Member

	Doh! And here I thought I was just slow at getting the setti... In forum Hardware, firmware and software help	před 6 years
	The surface temperature when set to 85 varies from 45 on the... In forum Hardware, firmware and software help	před 6 years
	I'll try to snap a photo when it happens again. The PETG par... In forum Hardware, firmware and software help	před 6 years
	PEI spring sheet lifting off the print bed In forum Hardware, firmware and software help	před 6 years

Fórum Statistiky

566 Fóra

63.2 K Témata

444.4 K Příspěvky

20 Online

68.1 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed