Prusa3D Forum

Notifications

Clear all

Enceladus42

Group: Registered

Joined: 2020/05/14

Eminent Member

	Does Firmware 3.14.0 work with Revo Hotend? In forum Hardware, firmware and software help	3 months ago
	That is a fantastic reply! Thank you sooo much 😀 Yes, it st... In forum Hardware, firmware and software help	2 years ago
	Previous print was white, this print was orange. Hope this w... In forum Hardware, firmware and software help	2 years ago
	Leakage between hot end and the bit above. help please. In forum Hardware, firmware and software help	2 years ago
	that looks like the problem. how do i fix it? In forum Hardware, firmware and software help	3 years ago
	heat block leaking. how to tighten? In forum Hardware, firmware and software help	3 years ago
	Many thanks for the replies. I'm using the speeds as set as ... In forum How do I print this? (Printing help)	4 years ago
	Very visible layer lines. How can i fix please? In forum How do I print this? (Printing help)	4 years ago
	@nikolai-r UK In forum How do I print this? (Printing help)	4 years ago
	the face should be smooth. got layer lines and slight shifts... In forum Improvements (Archive)	4 years ago
	Y axis layers not lining up (photo inc). Help would be appre... In forum Improvements (Archive)	4 years ago
	PETG Filament Recomendations ? In forum How do I print this? (Printing help)	4 years ago
	that's brilliant! thanks so much for your help 😀 In forum PrusaSlicer	4 years ago
	thanks. Er, how please? if i click on the height range modif... In forum PrusaSlicer	4 years ago
	is there a way to add more than one height range modifier? In forum PrusaSlicer	4 years ago
	oh that is brilliant! can put infil where it's most needed. ... In forum PrusaSlicer	4 years ago
	Infill adjustment by layer height? Is it possible? In forum PrusaSlicer	4 years ago
	just had another thought... prints are fine from the sd card... In forum Assembly and first prints troubleshooting	4 years ago
	i "think" i might have fixed it. released the screws holding... In forum Assembly and first prints troubleshooting	4 years ago
	thanks @neophyl got the drift down to the first 2mm or so by... In forum Assembly and first prints troubleshooting	4 years ago

Page 1 / 2 Next

Forum Statistics

565 Forums

63.4 K Topics

445.5 K Posts

21 Online

68.6 K Members

Latest Post: Excited about PrusaSlicer-2.9.0-beta1 Our newest member: Frickelfred Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed