Prusa3D Forum

Notifications

Clear all

Enceladus42

Groupe: Enregistré

A(ont) rejoint: 2020/05/14

Eminent Member

	Does Firmware 3.14.0 work with Revo Hotend? Dans le forum Hardware, firmware and software help	il y a 3 months
	That is a fantastic reply! Thank you sooo much 😀 Yes, it st... Dans le forum Hardware, firmware and software help	il y a 2 years
	Previous print was white, this print was orange. Hope this w... Dans le forum Hardware, firmware and software help	il y a 2 years
	Leakage between hot end and the bit above. help please. Dans le forum Hardware, firmware and software help	il y a 2 years
	that looks like the problem. how do i fix it? Dans le forum Hardware, firmware and software help	il y a 3 years
	heat block leaking. how to tighten? Dans le forum Hardware, firmware and software help	il y a 3 years
	Many thanks for the replies. I'm using the speeds as set as ... Dans le forum How do I print this? (Printing help)	il y a 4 years
	Very visible layer lines. How can i fix please? Dans le forum How do I print this? (Printing help)	il y a 4 years
	@nikolai-r UK Dans le forum How do I print this? (Printing help)	il y a 4 years
	the face should be smooth. got layer lines and slight shifts... Dans le forum Improvements (Archive)	il y a 4 years
	Y axis layers not lining up (photo inc). Help would be appre... Dans le forum Improvements (Archive)	il y a 4 years
	PETG Filament Recomendations ? Dans le forum How do I print this? (Printing help)	il y a 4 years
	that's brilliant! thanks so much for your help 😀 Dans le forum PrusaSlicer	il y a 4 years
	thanks. Er, how please? if i click on the height range modif... Dans le forum PrusaSlicer	il y a 4 years
	is there a way to add more than one height range modifier? Dans le forum PrusaSlicer	il y a 4 years
	oh that is brilliant! can put infil where it's most needed. ... Dans le forum PrusaSlicer	il y a 4 years
	Infill adjustment by layer height? Is it possible? Dans le forum PrusaSlicer	il y a 4 years
	just had another thought... prints are fine from the sd card... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	i "think" i might have fixed it. released the screws holding... Dans le forum Assembly and first prints troubleshooting	il y a 4 years
	thanks @neophyl got the drift down to the first 2mm or so by... Dans le forum Assembly and first prints troubleshooting	il y a 4 years

Page 1 / 2 Suivant

Statistiques du forum

565 Forums

63.4 K Sujets

445.5 K Messages

21 En-ligne

68.6 K Membres

Le dernier des messages: Modell aus PLA mit PETG als Support Notre nouveau membre: Frickelfred Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé