Prusa3D Forum

Notifications

Clear all

Enceladus42

Skupina: Registrovaný

Přidal se: 2020/05/14

Eminent Member

	Does Firmware 3.14.0 work with Revo Hotend? In forum Hardware, firmware and software help	před 12 months
	That is a fantastic reply! Thank you sooo much 😀 Yes, it st... In forum Hardware, firmware and software help	před 3 years
	Previous print was white, this print was orange. Hope this w... In forum Hardware, firmware and software help	před 3 years
	Leakage between hot end and the bit above. help please. In forum Hardware, firmware and software help	před 3 years
	that looks like the problem. how do i fix it? In forum Hardware, firmware and software help	před 4 years
	heat block leaking. how to tighten? In forum Hardware, firmware and software help	před 4 years
	Many thanks for the replies. I'm using the speeds as set as ... In forum How do I print this? (Printing help)	před 5 years
	Very visible layer lines. How can i fix please? In forum How do I print this? (Printing help)	před 5 years
	@nikolai-r UK In forum How do I print this? (Printing help)	před 5 years
	the face should be smooth. got layer lines and slight shifts... In forum Improvements (Archive)	před 5 years
	Y axis layers not lining up (photo inc). Help would be appre... In forum Improvements (Archive)	před 5 years
	PETG Filament Recomendations ? In forum How do I print this? (Printing help)	před 5 years
	that's brilliant! thanks so much for your help 😀 In forum PrusaSlicer	před 5 years
	thanks. Er, how please? if i click on the height range modif... In forum PrusaSlicer	před 5 years
	is there a way to add more than one height range modifier? In forum PrusaSlicer	před 5 years
	oh that is brilliant! can put infil where it's most needed. ... In forum PrusaSlicer	před 5 years
	Infill adjustment by layer height? Is it possible? In forum PrusaSlicer	před 5 years
	just had another thought... prints are fine from the sd card... In forum Assembly and first prints troubleshooting	před 5 years
	i "think" i might have fixed it. released the screws holding... In forum Assembly and first prints troubleshooting	před 5 years
	thanks @neophyl got the drift down to the first 2mm or so by... In forum Assembly and first prints troubleshooting	před 5 years

Stránka 1 / 2 Další

Fórum Statistiky

585 Fóra

68.3 K Témata

478.2 K Příspěvky

12 Online

76.1 K Uživatelé

Poslední Příspěvek: What filament dryer to use? Nový Uživatel: ArtiVIVO Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed