Notifications
Clear all
Eliot Lytle
Skupina: Registrovaný
Přidal se: 2023/12/08
Active Member
1
|
Ready for a good laugh? The wire and sensor were fine as wer... In forum Hardware, firmware and software help |
před 2 weeks | |
|
I'll go at it with the multi-meter this morning and see what... In forum Hardware, firmware and software help |
před 2 weeks | |
|
Filament Sensor Stuck on "1" In forum Hardware, firmware and software help |
před 2 weeks | |
| I replaced the whole hotend assembly and this cleared things... | před 9 months | |
| It's worth noting that when I plugged the Thermistor back in... | před 9 months | |
| I disconnected the Thermistor from the Buddy Board and did g... | před 9 months | |
| Maxtemp Error Print Head #12206 | před 9 months | |
|
We have quite a few Prusa MK3S+ printers here and all were u... In forum Hardware, firmware and software help |
před 12 months |